SnapVX relink operations when adding source devices
The relink operation can only be used if a link exists on at least one of the targets. In Copy mode, if a link already exists for a particular target, the result is an incremental copy. If there is no existing link for a target, then the result is a full copy.
If relinking from a source device that has the selected snapshot and generation, but the target device does not have an existing link, a new link is created and the result is a full copy.
If relinking from a source device that does not have the selected snapshot and generation, the target device is marked NR. If the target has an existing link, it is unlinked.
If relinking from a source device that has the selected snapshot and generation, and the target device has a previous link, the relink results in an incremental copy.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\