- Notes, cautions, and warnings
- Preface
- Introduction to TimeFinder SnapVX
- Performing TimeFinder SnapVX Operations
- Establish SnapVX snapshot
- Rename SnapVX snapshot
- Set SnapVX snapshot time to live (TTL)
- Set persistent SnapVX snapshot
- Convert SnapVX snapshot to secure snapshot
- Link a SnapVX snapshot
- Change SnapVX snapshot link mode
- Unlink SnapVX snapshot
- Relink SnapVX snapshot
- Restore SnapVX snapshot
- Terminate SnapVX snapshot
- TimeFinder SnapVX snapshot reporting
- TimeFinder SnapVX Configurations and Examples
- TimeFinder SnapVX State Reference Rules
- Determine SnapVX states/SRDF and ORS operations interaction
- State rules for TimeFinder SnapVX operations with SRDF pair states
- TimeFinder SnapVX operations with ORS pair states
- State rules for source control operations with SnapVX and Clone source states
- State rules for source control operations with SnapVX and Clone source states
Dell Solutions Enabler 10.0.0 TimeFinder SnapVX CLI User Guide
TimeFinder SnapVX operations with ORS pair states
Only the SnapVX
terminate command is allowed on the SnapVX source or target device that has ORS
rcopy push or pull sessions. The rcopy operation can be in the following states:
- None
- Create in prog
- Created
- Copy in progress
- Copy on write
- Copied
- Recreate in progress
- Recreated
- Terminate in Progress
- Failed
- Invalid
- Verify in progress
- Restore in progress
- Restored
- Precopy
- Sync in prog
- Syncronized
- Stopped
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\