- Notes, cautions, and warnings
- Preface
- Introduction to TimeFinder SnapVX
- Performing TimeFinder SnapVX Operations
- Establish SnapVX snapshot
- Rename SnapVX snapshot
- Set SnapVX snapshot time to live (TTL)
- Set persistent SnapVX snapshot
- Convert SnapVX snapshot to secure snapshot
- Link a SnapVX snapshot
- Change SnapVX snapshot link mode
- Unlink SnapVX snapshot
- Relink SnapVX snapshot
- Restore SnapVX snapshot
- Terminate SnapVX snapshot
- TimeFinder SnapVX snapshot reporting
- TimeFinder SnapVX Configurations and Examples
- TimeFinder SnapVX State Reference Rules
- Determine SnapVX states/SRDF and ORS operations interaction
- State rules for TimeFinder SnapVX operations with SRDF pair states
- TimeFinder SnapVX operations with ORS pair states
- State rules for source control operations with SnapVX and Clone source states
- State rules for source control operations with SnapVX and Clone source states
Dell Solutions Enabler 10.0.0 TimeFinder SnapVX CLI User Guide
Unlink SnapVX snapshot
Description
The symsnapvx unlink command unlinks a snapshot without relinking to a different snapshot.
NOTE:Allows the unlink of a link nocopy session when the session is defined and the target device is the source of another snapshot. The data is guaranteed as long as the define is complete at the time of the unlink operation.
Options
- -symforce
- Forces the operation to execute when normally it is rejected. If used when a link is copy in progress or when a restore is restore in progress, causes an incomplete copy and data on the copy target is not usable.
Example
To unlink generation 6 of the 600am snapshot, enter:
symsnapvx -sid 001 -sg StorageGroup1 -lnsg StorageGroup2 -snapshot_name 600am -gen 6 unlink
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\