Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

PowerProtect Data Manager 19.14 File System User Guide

PDF

Install the File System agent on Windows in silent mode

On Windows, review the following commands to perform a silent installation of the File System agent.

NOTE:The File System agent installer for Windows does not support the --help option. Running the installer program with --help initiates the actual installation process.

To perform the silent installation to the default path, run: 

fsagent-19.x.x.x.exe /s PPDMHostName=<PPDM_server_IP>

To perform the silent installation to a different path, run: 

fsagent-19.x.x.x.exe /s PPDMHostName=<PPDM_server_IP> 
ProductInstallPath="D:\alternate_path"

To enable the PowerProtect Data Manager default communications port 7000, if Windows firewall rules have not been previously configured, run: 

fsagent-19.x.x.x.exe /s PPDMHostName=<PPDM_server_IP> EnableFirewallRules=1

To enable the PowerProtect Data Manager communications port 7009 and preferred application host address (as FQDN) for communications, if Windows firewall rules have not been previously configured, run: 

fsagent-19.x.x.x.exe /s PPDMHostName=<PPDM_server_IP> EnableFirewallRules=1 AgentServicePort=7009 PreferredAddress=blrv167a202.ppdm.com

When EnableFirewallRules is enabled (set to '1'), the installation creates the Windows firewall rules that allows inbound and outbound connections for the agent service process. Installation of the File System agent requires a specified port on the File System agent host (specified from the supported port ranges 7000 to 7009 and 7012 to 7020) and the port 7001 on PowerProtect Data Manager to be open bidirectionally. These ports enable communication between the File System agent and PowerProtect Data Manager.

NOTE:If you do not specify a communications port on the File System agent host, the default port 7000 is used as the communications port. The ports 7010 and 7011 are used by the agent service message bus.

The change in EnableFirewallRules configuration will take place only on first-time installation or upgrade of the agent service.

In silent File System agent installation (in the case of coexistence), use the ForceUpgrade=1 option to cause the silent update of common components. If you do not add this option, the silent installation fails.

NOTE: PPDMHostName is a mandatory option in the command line. If a value is not provided, but the agent service component has been installed by another agent, installation will succeed, but without PowerProtect, and hence it will not be possible to initiate backups from the UI. If, however, the agent service component has not been installed by another agent, then installation will fail. Specifying ProductInstallPath is optional, but if used, the value cannot be empty. When the ProductInstallPath value is provided during update or coexistence, but the install path is not the same as that of the previously installed file system or already installed agents, installation fails.

Windows installer logs are retained at <System drive>\Users\<installing user>\AppData\Local\Temp, and should be consulted in the event of an installation failure. In silent mode, any error message is logged only in the Windows installer logs.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\