- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager File System Agent Overview
- Enabling the File System Agent
- About the File System agent
- Application agent and File System agent coexistence
- File System agent prerequisites
- File System agent limitations
- Block-based backups
- Best practices for file system backups
- Configure the file system parallel backup setting
- Configure asset multi-streaming for file-based backups
- Protect an asset with the File System agent
- Protect an asset in a Microsoft Windows Server clustered environment with the File System agent
- Installing and uninstalling the File System agent on AIX
- Installing and updating the File System agent on Linux
- Installing and updating the File System agent on Windows
- Manage the File System agent
- Configure the centralized file-level restore service port number
- Update the application agent in the PowerProtect Data Manager UI
- Moving a File System agent from one PowerProtect Data Manager system to another
- Enable the File System agent after migrating File System assets to a refreshed server
- Managing Storage, Assets, and Protection
- Enable an asset source
- Discover a file system host
- Protection policies for File System agent
- Supported protection policy purposes
- Supported protection policy objectives
- File System replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for file system protection
- Add a protection policy for file system protection
- Protection rules
- Cancel a File System agent backup or restore job
- Add a service-level agreement
- Extended retention for protection policies created in PowerProtect Data Manager 19.11 or earlier
- Edit the retention period for backup copies
- Delete backup copies
- Host CPU throttling
- Exclusion filters for File Systems
- Centralized restore of a file-system asset
- Updating the File System agent hostname or IP address
- Manage the PowerProtect agent service
- Performing Self-Service Backups and Restores with the File System Agent
- Performing Self-Service Backups and Restores for Disaster Recovery
- Performing Disaster Recovery with the File System Agent in Windows
- Disaster recovery limitations
- Preparing for disaster recovery
- Performing system-state recovery
- Recovering the Active Directory
- Performing bare-metal recovery
- Perform bare-metal recovery of Windows clusters
- Disaster recovery solution for Microsoft SQL application data
- Protecting Microsoft Distributed File System using BMR and SSR
- Performing application restores after bare-metal recovery
- File System Best Practices and Troubleshooting
- Glossary
PowerProtect Data Manager 19.14 File System User Guide
Reregister the File System agent on Windows
You can use the procedure in this topic to reregister the deleted File System agent to the same PowerProtect Data Manager system.
NOTE: You can use the
Modify option under
Add/Remove programs for the
File System agent to reregister the
File System agent with
PowerProtect Data Manager system only if you have not uninstalled the
File System agent and the PowerProtect agent service.
If you have cleaned up the installation directories and manually uninstalled both the File System agent and the PowerProtect agent service, then you must complete the installation procedures in Installing and updating the File System agent on Windows.
Alternatively, you can use the register.bat script to register and reregister the File System agent with PowerProtect Data Manager as follows:
<Install_folder>\AgentService\register.bat --enable
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\