Familiarize yourself with the high-level steps required to deploy
PowerProtect Data Manager with the
File System agent.
Steps
Design how to group the backups based on the storage requirements and retention policies.
The account team can help with backup storage design.
Install PowerProtect DD Management Center (DDMC).
PowerProtect Data Manager uses DDMC to connect to the DD systems. The
DD Management Center Installation and Administration Guide provides instructions.
Deploy
PowerProtect Data Manager from the download file.
The
PowerProtect Data Manager Deployment Guide provides instructions.
Add external DD systems or DDMC to
PowerProtect Data Manager.
The
PowerProtect Data Manager Administration and User Guide provides instructions on how to add protection storage.
Install the
File System agent on the appropriate hosts and connect them to
PowerProtect Data Manager according to the instructions in the next chapter.
Add new or approve pending agent requests in the
PowerProtect Data Manager according to the instructions in the next chapter.
Add a protection policy for groups of assets that you want to back up.
NOTE:After you create a centralized protection job, the first backup is a full backup.
The
PowerProtect Data Manager Administration and User Guide provides instructions.
Add Service Level Objectives to the protection policy to verify that the protected assets meet the service-level agreements (SLAs).
The
PowerProtect Data Manager Administration and User Guide provides instructions.
Now that the configuration is complete, it is recommended to perform a full backup so that
PowerProtect Data Manager can detect the proper backup chain.
Without a full backup,
PowerProtect Data Manager treats the backups as partial and assumes that you are out of compliance.
Monitor protection compliance in the
PowerProtect Data Manager dashboard.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\