Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerSwitch S3048-ON Installation Guide February 2024

PDF

ReadyRails system installation

The ReadyRails rack mounting system is provided to easily configure your rack for installation of your S3048–ON switch.

You can install the ReadyRails system using the 1U tool-less method or one of three 1U tooled methods—two-post flush mount, two-post center mount, or four-post threaded.

  1. With the ReadyRails flange ears facing outward, place one rail between the left and right vertical posts.
    Align and seat the rear flange rail pegs in the rear vertical post flange. In the following illustration, item 1 and its extractions show how the pegs appear in both the square and non-threaded round holes.
    Figure 1. 1U tool-less configuration
    Illustration of a 1U tool-less configuration.
  2. Align and seat the front flange pegs in the holes on the front side of the vertical post, item 2.
  3. Repeat this procedure for the second rail.
  4. To remove each rail, pull on the latch release button on each flange ear and unseat each rail, item 3.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\