- Notes, cautions, and warnings
- About this document
- Next Generation Modular overview
- Enclosure overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your enclosure
- After working inside your enclosure
- Hot plug and Non-hot plug devices
- Storage and compute sleds
- Cooling fan modules
- Power supply units
- Fabrics and modules
- Removing a blank from Fabric A or B slot
- Installing a blank in Fabric A or B slot
- Removing a module from Fabric A or B slot
- Installing a module in Fabric A or B slot
- Removing a MX7000 blank from Fabric C slot
- Installing a MX7000 blank in Fabric C slot
- Removing a MX7000 module from Fabric C slot
- Installing a MX7000 module into Fabric C slot
- Removing a management module blank
- Installing a management module blank
- Removing a management module
- Installing a management module
- Installing the second management module
- Support information for GPU
- Technical specifications
- Getting help
- Documentation resources
Dell EMC PowerEdge MX7000 Enclosure Installation and Service Manual
Expanded operating temperature restrictions
For more information about the expanded operating temperature restrictions, see the Installation and Service Manual for the PowerEdge MX sleds at www.dell.com/poweredgemanuals.
| System | C30 | C35 | C40E45 |
|---|---|---|---|
| Dell EMC PowerEdge MX7000 including the fans, Management Module, and PSUs | No restrictions | No restrictions | No restrictions |
| Fabrics A and B modules | No restrictions | No restrictions | The MX9116n is not supported. |
| Fabric C I/O modules | No restrictions | No restrictions | No restrictions |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\