- Notes, cautions, and warnings
- About this document
- Next Generation Modular overview
- Enclosure overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your enclosure
- After working inside your enclosure
- Hot plug and Non-hot plug devices
- Storage and compute sleds
- Cooling fan modules
- Power supply units
- Fabrics and modules
- Removing a blank from Fabric A or B slot
- Installing a blank in Fabric A or B slot
- Removing a module from Fabric A or B slot
- Installing a module in Fabric A or B slot
- Removing a MX7000 blank from Fabric C slot
- Installing a MX7000 blank in Fabric C slot
- Removing a MX7000 module from Fabric C slot
- Installing a MX7000 module into Fabric C slot
- Removing a management module blank
- Installing a management module blank
- Removing a management module
- Installing a management module
- Installing the second management module
- Support information for GPU
- Technical specifications
- Getting help
- Documentation resources
Dell EMC PowerEdge MX7000 Enclosure Installation and Service Manual
MXG610s Fibre Channel Switch
| Connector | Description |
|---|---|
| USB port | One micro USB 2.0-compliant port on the front of the sled. |
| Fibre Channel transceiver | 16 external ports supporting 8/ 16/ 32 Gbps speeds using 8 SFPs and 2 QSFPs. |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\