- Notes, cautions, and warnings
- About this document
- Next Generation Modular overview
- Enclosure overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your enclosure
- After working inside your enclosure
- Hot plug and Non-hot plug devices
- Storage and compute sleds
- Cooling fan modules
- Power supply units
- Fabrics and modules
- Removing a blank from Fabric A or B slot
- Installing a blank in Fabric A or B slot
- Removing a module from Fabric A or B slot
- Installing a module in Fabric A or B slot
- Removing a MX7000 blank from Fabric C slot
- Installing a MX7000 blank in Fabric C slot
- Removing a MX7000 module from Fabric C slot
- Installing a MX7000 module into Fabric C slot
- Removing a management module blank
- Installing a management module blank
- Removing a management module
- Installing a management module
- Installing the second management module
- Support information for GPU
- Technical specifications
- Getting help
- Documentation resources
Dell EMC PowerEdge MX7000 Enclosure Installation and Service Manual
Support information for GPU
The MX7000 system can support up to 16 T4 GPUs through the vendor module, Amulet Hotkey CoreModule. If you choose to install the Amulet Hotkey core modules, they could be installed in the Fabric B slots of the MX7000 chassis, however support for the vendor modules from Amulet Hotkey comes from Amulet Hotkey. The following list shows the email addresses by region for Amulet Hotkey's technical support:
- eurosupport@amulethotkey.com
- ussupport@amulethotkey.com
- latamsupport@amulethotkey.com
- apsupport@amulethotkey.com
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\