- Notes, cautions, and warnings
- About this document
- Next Generation Modular overview
- Enclosure overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your enclosure
- After working inside your enclosure
- Hot plug and Non-hot plug devices
- Storage and compute sleds
- Cooling fan modules
- Power supply units
- Fabrics and modules
- Removing a blank from Fabric A or B slot
- Installing a blank in Fabric A or B slot
- Removing a module from Fabric A or B slot
- Installing a module in Fabric A or B slot
- Removing a MX7000 blank from Fabric C slot
- Installing a MX7000 blank in Fabric C slot
- Removing a MX7000 module from Fabric C slot
- Installing a MX7000 module into Fabric C slot
- Removing a management module blank
- Installing a management module blank
- Removing a management module
- Installing a management module
- Installing the second management module
- Support information for GPU
- Technical specifications
- Getting help
- Documentation resources
Dell EMC PowerEdge MX7000 Enclosure Installation and Service Manual
Removing a sled blank
Prerequisites
- Follow the safety guidelines listed in Safety instructions.
Steps
- Press the release button to release the sled blank.
- Pull the sled blank out of the enclosure.CAUTION:Ensure to install a sled blank in all the empty bays. Operating the enclosure without a blank results in overheating.
Figure 1. Removing a sled blank 
Next steps
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\