Setting up your
enclosure
Complete the following steps to set up your
enclosure:
Steps
- Unpack the enclosure.
- Install
the enclosure into the rack. For more information, see the Rail Installation Guide at www.dell.com/poweredgemanuals.
- Connect the peripherals to the enclosure.
- Connect the enclosure to its electrical outlet.
- Power on the enclosure by pressing the power button.
NOTE:You can configure the static or DHCP IP address using the touch panel on the chassis.
- Power on the attached peripherals.
For more information about setting up your enclosure, see the Getting Started Guide that shipped with your enclosure.
Data is not available for the Topic