Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

fabric-id vlan

In an FCoE map, configure the association between the dedicated VLAN used to carry FCoE traffic between servers and a SAN, and the fabric where the desired storage arrays are installed.

Syntax

fabric-id fabric-num vlan vlan-id

Parameters

fabric-id fabric-num	Enter a fabric ID number that is the same as the ID number of the dedicated VLAN used to carry FCoE storage traffic to the fabric specified in the FCoE map. You can enter a fabric ID in the range 2–4094.
vlan vlan-id	Enter the ID number of the dedicated VLAN used to carry FCoE storage traffic between servers and a SAN fabric and specified with the `vlan` command in the FCoE map.

Defaults

None

Command Modes

FCOE MAP

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.6(0.0)	Supported on the FN 2210S Aggregator.
9.3(0.0)	Supported on the M I/O Aggregator.

Usage Information

In the fabric-id vlan command, the fabric and VLAN ID numbers must be the same.

In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must be unique.

To remove a fabric-VLAN association from an FCoE map, enter the no fabric-id vlan command.

Create a VLAN and then specify the configured VLAN ID in the fabric-id vlan command. Otherwise, the following error message is displayed.

 Dell(conf-fcoe-f)#fabric-id 10 vlan 10 % Error: Vlan 10 does not exist

Related Commands

fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers and a SAN fabric.

show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE maps.