Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

storm-control unknown-unicast (Interface)

Configure percentage of unknown-unicast traffic allowed on the interface.

Syntax

storm-control unknown-unicast [ packets_per_second in]

To disable unknown-unicast storm control on the interface, use the no storm-control unknown-unicast [ packets_per_second in] command.

Parameters

packets_per_second

Enter the packets per second of broadcast traffic allowed into the network. The range is from 0 to 33554431.

Command Modes

INTERFACE (conf-if- interface-slot/port)

Supported Modes

Programmable-Mux (PMUX)

Full–Switch Mode

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.