Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ipv6 flowlabel-zero

Configure system to set the flow label field in the packets to zero.

Syntax

ipv6 flowlabel-zero

To disable the 0 from being set in the field and allow the rotocol operations to fill the field, use the no ipv6 flowlabel-zero command.

Default

Disabled

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If the flowlabel value is already set for BGP or SSH, the system defaults to the already configured value. All packets on the same connection are considered part of the same flow by the system. For new connections, set the new flowlabel to zero.