Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show qos dcb-map

Display the DCB parameters configured in a specified DCB map.

Syntax

show qos dcb-map map-name

Parameters

map-name

Displays the PFC and ETS parameters configured in the specified map.

Command Modes

EXEC
EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.6(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.

Usage Information

Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and priority-based flow control (PFC) parameters used to configure server-facing Ethernet ports.

The following table describes the show qos dcb-map output shown in the example below.

Field	Description
State	Complete: All mandatory DCB parameters are correctly configured. In progress: The DCB map configuration is not complete. Some mandatory parameters are not configured.
PFC Mode	PFC configuration in DCB map: On (enabled) or Off.
PG	Priority group configured in the DCB map.
TSA	Transmission scheduling algorithm used by the priority group: Enhanced Transmission Selection (ETS).
BW	Percentage of bandwidth allocated to the priority group.
PFC	PFC setting for the priority group: On (enabled) or Off.
Priorities	802.1p priorities configured in the priority group.

Example

Dell# show qos dcb-map dcbmap2
                                             
                                             State   :Complete
                                             PfcMode:ON
                                             --------------------
                                             PG:0 TSA:ETS  BW:50  PFC:OFF
                                             Priorities:0 1 2 4 5 6 7
                                             
                                             
                                             PG:1 TSA:ETS  BW:50  PFC:ON
                                             Priorities:3