Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

seq

To a deny or permit filter in a prefix list while configuring the filter, assign a sequence number.

Syntax

seq sequence-number {deny | permit} {any} | [ ip-prefix / nn {ge min-prefix-length} {le max-prefix-length}] | [bitmask number]

Parameters

sequence-number	Enter a number. The range is from 1 to 4294967294.
deny	Enter the keyword `deny` to configure a filter to drop packets meeting this condition..
permit	Enter the keyword `permit` to configure a filter to forward packets meeting this condition.
any	(OPTIONAL) Enter the keyword `any` to match any packets.
ip-prefix /nn	(OPTIONAL) Specify an IP prefix in the network/length format. For example, 35.0.0.0/8 means match the first 8 bits of address 35.0.0.0.
ge min-prefix-length	(OPTIONAL) Enter the keyword `ge` and then enter the minimum prefix length, which is a number from zero (0) to 32.
le max-prefix-length	(OPTIONAL) Enter the keyword `le` and then enter the maximum prefix length, which is a number from zero (0) to 32.
bitmask number	Enter the keyword `bitmask` then enter a bit mask number in dotted decimal format.

Defaults

Not configured.

Command Modes

PREFIX-LIST

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If you do not use the ge or le options, only packets with an exact match to the prefix are filtered.

Related Commands

deny — configures a filter to drop packets.

permit — configures a filter to pass packets.