Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show hosts

View the host table and DNS configuration.

Syntax

show hosts

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show hosts command in the following example.

Field	Description
Default domain...	Displays the domain name (if configured).
Name/address lookup...	States if DNS is enabled on the system. If DNS is enabled, the Name/Address lookup is domain service. If DNS is not enabled, the Name/Address lookup is static mapping
Name servers are...	Lists the name servers, if configured.
Host	Displays the host name assigned to the IP address.
Flags	Classifies the entry as one of the following: perm — the entry was manually configured and will not time out temp — the entry was learned and will time out after 72 hours of inactivity. Also included in the flag is an indication of the validity of the route: ok — the entry is valid. ex — the entry expired. ?? — the entry is suspect.
TTL	Displays the amount of time until the entry ages out of the cache. For dynamically learned entries only.
Type	Displays IP as the type of entry.
Address	Displays the IP addresses assigned to the host.

Example

Dell#show hosts
                                             Default domain is not set
                                             Name/address lookup uses static mappings
                                             Name servers are not set
                                             Host     Flags     TTL   Type   Address
                                             -------- -----     ----  ----   -------
                                             ks      (perm, OK) -     IP     2.2.2.2
                                             4200-1  (perm, OK) -     IP     192.68.69.2
                                             1230-3  (perm, OK) -     IP     192.68.99.2
                                             ZZr     (perm, OK) -     IP     192.71.18.2
                                             Z10-3   (perm, OK) -     IP     192.71.23.1
                                             Dell#

Related Commands

traceroute — views the DNS resolution.

ip host — configures a host.