Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ipv6 ospf interface

View OSPFv3 interface information.

Syntax show ipv6 ospf [ interface]
Parameters
interface

(OPTIONAL) Enter one of the following keywords and slot/port or number information:

  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet and the slot/port information.
  • For a Port Channel interface, enter the keywords port-channel and a number. The range is from 1 to 128.
  • For a Tunnel interface, enter the keywords tunnel and a number. The range is from 1 to 16383.
  • For a VLAN, enter the keyword vlan and a number from 1 to 4094.
Defaults none
Command Modes

EXEC

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information

If you enable BFD at the global level, show ipv6 ospf interface shows the BFD provisioning.

If you enable BFD at the interface level, show ipv6 ospf interface shows the BFD interval timers.

Example
Dell#show ipv6 ospf interface Tengigabitethernet 1/0
                                             
                                             TenGigabitEthernet 1/0 is up, line protocol is up
                                             Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID 67420217
                                             Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
                                             NetworkType BROADCAST, Cost: 1, Passive: No
                                             Transmit Delay is 100 sec, State DR, Priority 1
                                             Interface is using OSPF global mode BFD configuration.
                                             Designated router on this network is 11.1.1.1 (local)
                                             No backup designated router on this network
                                             Timer intervals configured, Hello 10, Dead 40, Wait 1, Retransmit 5
                                             
                                             Dell#
                                             
                                          

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\