Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor ebgp-multihop

Attempt and accept BGP connections to external peers on networks that are not directly connected.

Syntax

neighbor { ipv6-address | peer-group-name} ebgp-multihop [ ttl]

To disallow and disconnect connections, use the no neighbor { ipv6-address | peer-group-name} ebgp-multihop [ ttl] command.

Parameters

ipv6-address	Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name	Enter the name of the peer group.
ttl	(OPTIONAL) Enter the number of hops as the time to live (ttl) value. The range is from 1 to 255. The default is 255.

Defaults

Disabled.

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

To prevent loops, the neighbor ebgp-multihop command does not install default routes of the multihop peer. Networks not directly connected are not considered valid for best path selection.