Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

delay-restore abort-threshold

Increase the Boot Up timer to some value (>60 seconds).

Syntax

delay-restore abort-threshold <interval>

To remove use the no delay-restore abort-threshold command.

Defaults

60 seconds

Command Modes

VLT DOMAIN

Supported Modes

Full–Switch

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.7(0.0)	Introduced on Supported on the MXL 10/40GbE Switch IO Module.

Parameter

Enter the value (in seconds) to specify the time interval for delay restore timer to abort. This timer is applicable only during reload/boot-up and not in other scenarios (example, ICL flap).

The range is from 1 to 1800 seconds.

Usage Information

To abort VLT delay restore timer as the maximum threshold, the maximum time interval is applied to hold down ICL peer-up in the start-up configurations during the reload.