Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

network

Specify the networks for the BGP process and enter them in the BGP routing table.

Syntax

network ip-address mask [route-map map-name]

To remove a network, use the no network ip-address mask [route-map map-name] command.

Parameters

ip-address

Enter an IP address in dotted decimal format of the network.

mask

Enter the mask of the IP address in the slash prefix length format (for example, /24).

The mask appears in command outputs in dotted decimal format (A.B.C.D).

route-map map-name

(OPTIONAL) Enter the keyword route-map then the name of an established route map.

Only the following ROUTE-MAP mode commands are supported:

If the route map is not configured, the default is deny (to drop all routes).

Defaults

Not configured.

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The system software resolves the network address the network command configures with the routes in the main routing table to ensure that the networks are reachable using non-BGP routes and non-default routes.

Related Commands

redistribute — redistributes routes into BGP.