Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip ftp source-interface

Specify an interface’s IP address as the source IP address for FTP connections.

Syntax

ip ftp source-interface interface

Parameters

interface

Enter the following keywords and slot/port or number information:

For Loopback interfaces, enter the keyword loopback then a number from zero (0) to 16383.
For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults

The IP address on the system that is closest to the Telnet address is used in the outgoing packets.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Related Commands

copy — copies files from and to the switch.