Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show uplink-state-group

Display status information on a specified uplink-state group or all groups.

Syntax

show uplink-state-group [ group-id] [detail]

Parameters

group-id	Displays status information on a specified uplink-state group or all groups. The valid group-id values are from 1 to 16.
detail	Displays additional status information on the upstream and downstream interfaces in each group

Defaults

none

Command Modes

EXEC
EXEC Privilege

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.

Example

Dell#show uplink-state-group detail
                                             
                                             (Up): Interface up   (Dwn): Interface down   (Dis): Interface disabled
                                             
                                             Uplink State Group    : 1       Status: Enabled, Up
                                             Defer Timer           : 10 sec
                                             Upstream Interfaces   : Po 128(Up)
                                             Downstream Interfaces : Te 0/1(Dwn) Te 0/2(Dwn) Te 0/3(Up) Te 0/4(Dwn) Te 0/5(Up)
                                             Te 0/6(Dwn) Te 0/7(Up) Te 0/8(Up)
                                             
                                             Dell#

Related Commands

show running-config uplink-state-group — displays the current configuration of one or more uplink-state groups.
uplink-state-group — create an uplink-state group and enables the tracking of upstream links.