Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show crypto ipsec policy

Display the crypto policy configuration.

Syntax

show crypto ipsec policy name

Parameters

name

Enter the name for the crypto policy set.

Command Modes

EXEC

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell(conf-crypto-policy)#do show crypto ipsec policy
                                             
                                             Policy name           : pol1
                                             Policy refcount       : 0
                                             Sequence Num          : 1
                                             SA Mode               : IPSEC-MANUAL
                                             Transform-Set Name    :
                                             Peer IP Address       :
                                             Inbound AH SPI        : 0
                                             Inbound ESP Auth SPI  : 0
                                             Inbound ESP Encry SPI : 0
                                             Inbound AH Key        : [0]::
                                             Inbound ESP Auth Key  : [0]::
                                             Inbound ESP Encry Key : [0]::
                                             Outbound AH SPI       : 0
                                             Outbound ESP Auth SPI : 0
                                             Outbound ESP Encry SPI: 0
                                             Outound AH Key        : [0]::
                                             Outound ESP Auth Key  : [0]::
                                             Outound ESP Encry Key : [0]::
                                             
                                             Match sequence Num    : 2
                                             Protocol type         : tcp
                                             IP or IPv6            : IP
                                             Source address        : 1.1.1.1
                                             Source mask           : /32
                                             Source port           : 0
                                             Destination address   : 1.1.1.2
                                             Destination mask      : /32
                                             Destination port      : 23
                                             source-interface name :
                                             source-interface num  :
                                             
                                             Dell(conf-crypto-policy)#