Dell PowerEdge FC630 Owner's Manual

Installing the hard drive or SSD cage

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

NOTE: You must remove the hard drive or SSD cage to replace a faulty hard drive or SSD cage or service other components inside the system.

Follow the safety guidelines listed in safety instructions section.
Keep the Phillips #1 screwdriver ready.
Remove the hard drive or SSD cage, see the Removing the hard drive or SSD cage section.

Align the slots on the sides of the hard drive or SSD cage with the standoffs on the chassis.
Lower the hard drive or SSD cage into the chassis until the slots on the hard drive or SSD cage engage with the standoffs on the chassis.
Slide the hard drive or SSD cage into the chassis till it clicks into position.
Install the two screws to secure the hard drive or SSD cage to the chassis.
Figure 1. Installing the hard drive or SSD cage
1. standoff (4)
2. hard drive or SSD cage
3. screw (2)
4. screw hole (2)

Install the hard drive or SSD backplane. See the Installing the hard drive backplane section.
Install the hard drive or SSDs.
Follow the procedure listed in the After working inside your system section.

Bienvenue

Bienvenue dans l’univers Dell

Dell PowerEdge FC630 Owner's Manual

Installing the hard drive or SSD cage

Évaluez ce contenu