Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Profitez de récompenses et de remises réservées aux membres
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.

Dell PowerEdge FC630 Owner's Manual

Installing the optional rSPI card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the rSPI card to replace a faulty rSPI card or service other components inside the system.
CAUTION: To prevent damage to the rSPI card, you must hold the card only by its edges.
  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  3. Remove the rSPI card.

  1. Align the two screw holes on the rSPI card with the standoffs on the system board.
  2. Install the two screws to secure the rSPI card to the system board.
    Figure 1. Installing the optional rSPI card
    This figure shows installing the optional rSPI card.
    1. screw (2)
    2. rSPI card
    3. standoff (2)
    4. connector
Follow the procedure listed in the After working inside your system section.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\