Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Profitez de récompenses et de remises réservées aux membres
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.

Dell PowerEdge FC630 Owner's Manual

Removing the Network Daughter Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  3. Follow the procedure listed in the Before working inside your system section.

  4. Remove the PCIe mezzanine card. See the Removing the PCIe mezzanine card section.

  1. Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
  2. Lift the card from the system board.
    Figure 1. Removing the NDC
    This figure shows Removing the NDC.
    1. slot on the NDC
    2. screw (2)
    3. NDC
    4. standoff (2)
    5. connector on the system board
    6. tab projections
  1. Install the NDC. See the Installing the Network Daughter Card section.

  2. Install the PCIe mezzanine card. See the Installing the PCIe Mezz Card section.

  3. Follow the procedure listed in the After working inside your system section.


Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\