Passer au contenu principal
Quitter

Bienvenue dans l’univers Dell

Mon compte
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Profitez de récompenses et de remises réservées aux membres
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Se connecter Créer un compte Connexion au compte Premier Connexion au programme de partenariat
Nous contacter

Vos paniers Dell.com

Dell PowerEdge FC630 Owner's Manual

PDF

Removing the hard drive or SSD backplane

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

  1. Follow the safety guidelines listed in safety instructions section..

  2. Keep the Phillips #2 screwdriver ready.

  3. Follow the procedure listed in Before working inside your system section.

    CAUTION: To prevent damage to the hard drives or SSDs and the hard drive or SSD backplane, you must remove the hard drives or SSDs from the sled before removing the hard drive or SSD backplane.
    CAUTION: You must note the number of each hard drive or SSD and temporarily label them before removal so that you can replace them in the same locations.

  4. Remove the hard drive(s) or SSD(s).

  1. Loosen the two retention screws securing the hard drive or SSD backplane to the hard drive or SSD cage.
  2. Lift the hard drive or SSD backplane by its edges till the guide pin on the hard drive or SSD cage disengages with the guide on the hard drive or SSD backplane.
  3. Remove the hard drive or SSD cage. See the Removing the hard drive or SSD Cage section.
  4. Loosen the two retention screws securing the hard drive or SSD backplane cable connector to the system board connector.
  5. Lift the backplane up and away from the system.
    Figure 1. Removing the hard drive or SSD backplane
    This figure shows removing a hard drive or SSD backplane.
    1. hard drive or SSD backplane
    2. hard drive or SSD backplane cable
    3. retention screw (2)
    4. screw hole on the hard drive or SSD cage (2)
    5. guide pin
    6. retention screw on the hard drive or SSD backplane cable connector (2)
    7. connector

  1. Install the hard drive or SSD backplane, see the Installing the hard drive backplane section.

  2. Install the hard drive or SSD.

  3. Follow the procedure listed in the After working inside your system section.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\