Dell PowerEdge FC630 Owner's Manual

Installing the system board

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

NOTE: You must remove the system board to replace a faulty system board.

Follow the safety guidelines listed in safety instructions section.
Keep the Phillips #2 screwdriver and the Hex nut driver-5 mm ready.
Remove the system board. See the Removing the System Board section.
Unpack the new system board assembly.

CAUTION: Do not lift the system board by holding a memory module, processor, or other components.

CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.

Hold the system board by its edges and align the USB connectors with the slots on the front wall of the chassis.
Lower the system board until the system board is firmly seated on the chassis.
Install the screws to secure the system board to the chassis.
Figure 1. Installing the system board
1. hex nut screw (4)
2. system board
3. screw (10)
4. system board handle

Install the Trusted Platform Module (TPM). For information about how to install TPM, see the Installing the trusted platform modules section. For information about TPM, see the Trusted Platform Module section.
Install the following:
1. Internal USB key
2. SD vFlash card
3. IDSDM or rSPI card
4. NDC or LOM riser card
5. PCIe mezzanine card
6. PCIe extender or storage controller card
7. Hard drive or SSD cage
8. Hard drive or SSD backplane
9. Hard drive(s) or SSD(s)
  NOTE: Ensure that you reinstall the hard drives or SSDs in their original locations.
10. Cooling shroud
11. Memory modules
12. Processor(s) and heat sink(s)
Follow the procedure listed in the After working inside your system section.
NOTE: If you are not installing the sled in the enclosure, install the I/O connector cover.
Import your new or existing iDRAC Enterprise license. See the iDRAC8 User's Guide at Dell.com/idracmanuals.
Ensure that you:
1. Use the Easy Restore feature to restore the Service Tag. For more information, see the Restoring the Service Tag using Easy Restore section.
2. If the Service Tag is not backed up in the backup flash device, enter the system Service Tag manually. For more information, see the Entering the system Service Tag section.
3. Update the BIOS and iDRAC versions.
4. Reenable the Trusted Platform Module (TPM). For more information, see the Reenabling the TPM for BitLocker users section or the Reenabling the TPM for Intel TXT users section.

Bienvenue

Bienvenue dans l’univers Dell

Dell PowerEdge FC630 Owner's Manual

Installing the system board

Évaluez ce contenu