Dell PowerEdge FC630 Owner's Manual

Setting up your system

Complete the following steps to set up your system:

1. Unpack the sled.
2. Remove the I/O connector cover from the sled connectors.
   CAUTION: While installing the sled, ensure that it is properly aligned with the slot on the enclosure to prevent damage to the sled connectors.
3. Install the sled in the enclosure.
4. Turn on the enclosure.
   NOTE: Wait for the chassis to initialize before you press the power button.
5. Turn on the sled by pressing the power button on the sled.
   Alternatively, you can also turn on the sled by using:

   • The sled iDRAC. For more information, see the Log in to iDRAC section.

   • The enclosure Chassis Management Controller (CMC), after the sled iDRAC is configured on the CMC. For more information, see the CMC User’s Guide at Dell.com/idracmanuals.