Dell PowerEdge FC630 Owner's Manual

Troubleshooting system memory

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: Before performing the following procedure, ensure that you have installed the memory modules according to the memory installation guidelines for the sled.

Restart the sled:
1. Press the power button after to turn off the sled.
2. Press the power button again to apply power to the sled.
  If no error messages appear, go to step 8.
Enter the System Setup and check the system memory setting.
If the amount of memory installed matches the system memory setting, go to step 8.
Remove the sled from the enclosure.
Open the sled.
CAUTION: The memory modules are hot to touch for some time after the sled has been powered down. Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components.
Reseat the memory modules in their sockets.
Close the sled.
Install the sled in the enclosure.
Run the appropriate diagnostic test. For more information, see the Using system diagnostics section.
If the test fails, see the Getting help section.

Bienvenue

Bienvenue dans l’univers Dell

Dell PowerEdge FC630 Owner's Manual

Troubleshooting system memory

Évaluez ce contenu