Dell PowerEdge R760 Installation and Service Manual

EDSFF E3.S drive led codes

The LEDs on the drive carrier indicate the state of each drive. The LEDs on the EDSFF E3.S drive have two LEDs: an activity LED (green) and a locate/fault LED (blue/amber). The activity LED blinks whenever the drive is accessed.

EDSFF E3.S drive led codes

This image shows EDSFF E3.S drive indicators — Figure 1. EDSFF E3.S drive indicators

E3.S hard drives have Green LED and Blue/Amber LED.

Green LED shows : Drive power status , Activity
Blue/Amber LED shows: Drive Fault, Locate

EDSFF indicator behavior

Table 1. EDSFF indicator behaviorThis table shows EDSFF indicator behavior.
Pattern Name	Description	Blue Element	Amber Element
Locate	This device is being identified.	ON (1 sec ON 1 sec OFF)	OFF
Fault	The device is in a fault condition.	OFF	ON (2 sec ON 1 sec OFF)
N/A	This device does not have fault or locate device.	OFF	OFF

NOTE:Locate behavior overrides Fault state.

Green LED

The green LED is driven and controlled by the device. The two functions for this LED are defined as follows:

Power: This function indicates that the device has power and has no issues with its power regulation. Once the green LED is ON, it shall either remain ON or blink at the activity frequency unless the device determines power is no longer within its operating range.
Activity: This function indicates if the device is being used.

Table 2. LED and device state per function for Green LEDLED and device state per function for Green LED
Function/Device state	LED state
Power ON/Device is powered, no activity occurring.	ON
Activity/Device is powered, host initiated I/O activity occurring.	4 Hz nominal blink rate
Power OFF/Device is not powered.	OFF

歡迎

歡迎來到 Dell

Dell PowerEdge R760 Installation and Service Manual

EDSFF E3.S drive led codes

EDSFF E3.S drive led codes

對此內容評分