跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R760 Installation and Service Manual

PDF

Installing the 2 x 2.5-inch rear drive module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If required, remove the air shroud.
  4. Remove the drives.
  5. Disconnect the cables from the rear drive module.
    NOTE:Refer to cable routing section for more information.

Steps

  1. Align the slot on the rear drive module with the guide on the system.
  2. Lower and press the rear drive module on top of the riser until firmly seated.
  3. Using a Phillips #2 screwdriver, tighten the captive screws that secure the rear drive module into the system.
    Figure 1. Installing the 2 x 2.5-inch rear drive module
    This image shows Installing the 2 x 2.5-inch rear drive module

Next steps

  1. Connect and route all the cables to the rear drive module.
  2. Install the drives.
  3. If removed, install the air shroud.
  4. Follow the procedure listed in After working inside your system.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\