Dell PowerEdge R760 Installation and Service Manual

Removing the processor

Prerequisites

WARNING:Remove the processor from Direct Liquid Cooling (DLC) module only if you are replacing the processor or DLC module.

NOTE:Removing the Xeon Max processor from DLC module is the same as processor and heat sink module (PHM).

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Remove the air shroud or remove the GPU air shroud.
Remove the Direct Liquid Cooling module.

CAUTION:You may find the CMOS battery loss or CMOS checksum error that is displayed during the first instance of powering on the system after the processor or system board replacement which is expected. To fix this, go to setup option to configure the system settings.

Steps

Place the DLC module with the processor side facing up.
Using your thumb, lift the thermal interface material (TIM) break lever to release the processor from the TIM and retaining clip.
Holding the processor by the edges, lift the processor away from the retaining clip.
NOTE:Ensure to hold the retaining clip to the heat sink as you lift the TIM break lever.
Figure 1. Lift up the TIM break lever
NOTE:Ensure to return the TIM break lever back to original position.
Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the retaining clip release tab, and then lift the retaining clip partially from the DLC module.
Repeat the procedure at the remaining three corners of the retaining clip.
After all the corners are released from the DLC module, lift the retaining clip from the pin 1 corner of the DLC module.
Figure 2. Removing the retaining clip

Next steps

Replace the processor.

歡迎

歡迎來到 Dell

Dell PowerEdge R760 Installation and Service Manual

Removing the processor

Prerequisites

Steps

Next steps

對此內容評分