跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R760 Installation and Service Manual

PDF

Removing the processor

Prerequisites

WARNING:Remove the processor from processor and heat sink module (PHM) only if you are replacing the processor or heat sink.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud or remove the GPU air shroud.
  4. Remove the processor heat sink module.
CAUTION:You may find the CMOS battery loss or CMOS checksum error that is displayed during the first instance of powering on the system after the processor or system board replacement which is expected. To fix this, simply go to setup option to configure the system settings.

Steps

  1. Place the heat sink with the processor side facing up.
  2. Using your thumb, lift the thermal interface material (TIM) break lever to release the processor from the TIM and retaining clip.
    NOTE:For Xeon Max processor, turn the side lever (up to 60 degrees) with the flat blade screwdriver to release the Xeon Max processor from the TIM and retaining clip.
  3. Holding the processor by the edges, lift the processor away from the retaining clip.
    NOTE:Ensure to hold the retaining clip to the heat sink as you lift the TIM break lever.
    Figure 1. Removing the processor
    This image shows removing the processor
    Figure 2. Removing the Xeon Max processor
    This image shows removing the processor
    NOTE:Ensure to return the TIM break lever or side lever on the retaining clip back to original position.
  4. Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the retaining clip release tab, and then lift the retaining clip partially from the heat sink.
  5. Repeat the procedure at the remaining three corners of the retaining clip.
  6. After all the corners are released from the heat sink, lift the retaining clip from the pin 1 corner of the heat sink.
    Figure 3. Removing the retaining clip
    This image shows Removing the retaining clip
    Figure 4. Removing the Xeon Max retaining clip
    This image shows Removing the retaining clip

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\