Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC Configuration Guide for the S4048T–ON System 9.14.2.4

PDF

Changing VRRP Session Parameters

BFD sessions are configured with default intervals and a default role.

The parameters that you can configure are: Desired TX Interval, Required Min RX Interval, Detection Multiplier, and system role. You can change parameters for all VRRP sessions or for a particular neighbor.

To change parameters for all VRRP sessions or for a particular VRRP session, use the following commands.

  • Change parameters for all VRRP sessions.
    INTERFACE mode
    vrrp bfd all-neighbors interval milliseconds min_rx milliseconds multiplier value role [active | passive]
  • Change parameters for a particular VRRP session.
    INTERFACE mode
    vrrp bfd neighbor ip-address interval milliseconds min_rx milliseconds multiplier value role [active | passive]
To view session parameters, use the show bfd neighbors detail command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\