Dell EMC Configuration Guide for the S4048T–ON System 9.14.2.4

Examples of the show interfaces dampening Commands

To view the link dampening configuration on an interface, use the show config command.

R1(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
  ip address 10.10.19.1/24
  dampening 1 2 3 4
  no shutdown

To view dampening information on all or specific dampened interfaces, use the show interfaces dampening command from EXEC Privilege mode.

DellEMC#show interfaces dampening
Interface   Supp    Flaps   Penalty Half-Life   Reuse   Suppress    Max-Sup
            State
Te 1/1      Up      0       0       1           2       3           4
Te 1/2      Up      0       0       1           2       3           4
Te 1/2      Up      0       0       1           2       3           4
DellEMC# 

To view a dampening summary for the entire system, use the show interfaces dampening summary command from EXEC Privilege mode.

DellEMC# show interfaces dampening summary
20 interfaces are configured with dampening. 3 interfaces are currently suppressed.
Following interfaces are currently suppressed:
Te 1/2
Te 3/1
Te 4/2
DellEMC#