Dell EMC Configuration Guide for the S4048T–ON System 9.14.2.4

Enabling and Disabling a Port using SNMP

To enable and disable a port using SNMP, use the following commands.

1. Create an SNMP community on the Dell system.
   CONFIGURATION mode
   snmp-server community
2. From the Dell EMC Networking system, identify the interface index of the port for which you want to change the admin status.
   EXEC Privilege mode
   show interface
   Or, from the management system, use the snmpwwalk command to identify the interface index.
3. Enter the snmpset command to change the admin status using either the object descriptor or the OID.
   snmpset with descriptor: snmpset -v version -c community agent-ip ifAdminStatus.ifindex i {1 | 2}
   snmpset with OID: snmpset -v version -c community agent-ip .1.3.6.1.2.1.2.2.1.7.ifindex i {1 | 2}
   Choose integer 1 to change the admin status to Up, or 2 to change the admin status to Down.