Dell EMC Configuration Guide for the S4048T–ON System 9.14.2.4

Configuring the Control VLAN

Control and member VLANS are configured normally for Layer 2. Their status as control or member is determined at the FRRP group commands.

1. Create a VLAN with this ID number.
   CONFIGURATION mode.
   interface vlan vlan-id
   VLAN ID: from 1 to 4094.
2. Tag the specified interface or range of interfaces to this VLAN.
   CONFIG-INT-VLAN mode.
   tagged interface {range}
   Interface:

   • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
   • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
3. Assign the Primary and Secondary ports and the control VLAN for the ports on the ring.
   CONFIG-FRRP mode.
   interface primary interface secondary interface control-vlan vlan id
   Interface:

   • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
   • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
4. Configure the Master node.
   CONFIG-FRRP mode.
   mode master
5. Identify the Member VLANs for this FRRP group.
   CONFIG-FRRP mode.
   member-vlan vlan-id {range}
   VLAN-ID, Range: VLAN IDs for the ring’s member VLANS.
6. Enable FRRP.
   CONFIG-FRRP mode.
   no disable