Dell EMC Configuration Guide for the S4048T–ON System 9.14.2.4

Configuring IPv6 MBGP between peers

To configure IPv6 MBGP, use the following commands.

• Enter the router configuration mode and the AS number.
  CONFIG mode
  router bgp as-number
• Add the IP address of the neighbor for the specified autonomous system.
  CONFIG-ROUTER-BGP mode
  neighbor {ip-address | ipv6–address | peer-group-name} remote-as as-number
• Specify the IPv6 address family configuration.
  CONFIG-ROUTER-BGP mode
  address-family ipv6 [unicast | vrf vrf-name]
  unicast — Specifies the IPv6 unicast address family. The default address-family is IPv6 unicast.
  vrf vrf-name — Specifies the name of VRF instance associated with the IPv6 address-family configuration.
• Enable the neighbor to exchange prefixes for IPv6 unicast address family.
  CONFIG-ROUTER-BGP-AF (Address Family) mode
  neighbor {ip-address | ipv6–address | peer-group-name} activate

DellEMC(conf)# router bgp 10
DellEMC(conf-router_bgp)# neighbor 2001::1 remote-as 200
DellEMC(conf-router_bgp)# neighbor 2001::1 no shutdown
DellEMC(conf-router_bgp)# address-family ipv6 unicast
DellEMC(conf-router_bgpv6_af)#neighbor 2001::1 activate
DellEMC(conf-router_bgpv6_af)#exit

DellEMC#show ip bgp ipv6 unicast summary
BGP router identifier 1.1.1.1, local AS number 10
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
1 neighbor(s) using 8192 bytes of memory

Neighbor        AS            MsgRcvd  MsgSent     TblVer  InQ  OutQ Up/Down  State/Pfx
2001::1         200                 0        0          0    0     0 00:00:00 0
DellEMC#