Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

Configure Management IP address

To remotely access OS10, assign an IP address to the management port. Use the management interface for out-of-band (OOB) switch management.

  1. Configure the management interface from CONFIGURATION mode. 
    interface mgmt 1/1/1
  2. By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode. 
    no ip address dhcp
  3. Configure an IPv4 or IPv6 address on the Management interface in INTERFACE mode. 
    ip address A.B.C.D/mask
    ipv6 address A:B/prefix-length
  4. Enable the Management interface in INTERFACE mode.
    no shutdown

Configure Management interface

OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24
OS10(conf-if-ma-1/1/1)# no shutdown

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\