Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

load-balancing

Distributes or load balances incoming traffic using the default parameters in the hash algorithm.

Syntax
load-balancing {ingress-port enable | [tcp-udp-selection l4–destination-port | l4–source-port] | [ip-selection destination-ip | source-ip | protocol | vlan-id | l4–destination-port | l4–source-port] | [ipv6–selection destination-ip | source-ip | protocol | vlan-id | l4–destination-port | l4–source-port] | [mac-selection destination-mac | source-mac | ethertype | vlan-id]}
Parameters
  • ingress-port enable — Enables load-balancing on ingress ports.
  • tcp-udp-selection — Enables the TCP UDP port for the load-balancing configuration.
  • ip-selection — Enables IPv4 key parameters to use in the hash computation.
  • ipv6-selection — Enables IPV6 key parameters to use in hash computation.
  • destination-ip — Enables the destination IP address in the hash calculation.
  • source-ip — Enables the source IP address in the hash calculation.
  • protocol — Enables protocol information in the hash calculation.
  • vlan-id — Enables VLAN ID information in the hash calculation.
  • l4-destination-port — Enables Layer 4 (L4) destination port information in the hash calculation.
  • l4-source-port — Enables L4 source port information in the hash calculation.
  • mac-selection — Enables MAC load-balancing configurations.
  • destination-mac— Enables destination MAC information in the hash calculation.
  • source-mac— Enables source MAC information in the hash calculation.
  • ethertype — Enables Ethernet type information in the hash calculation.
Default
  • ip-selelection—source—ip dest-ip vlan-id l4–source-port l4–dest-port ipv4 protocol
  • ipv6-selection—source—ipv6 dest-ipv6 vlan—id l4–source-port l4–dest-port ipv6 protocol
  • mac-selection—source—mac destination—mac vlan-id ethertype
  • tcp-udp-selection—l4–source-port l4–dest-port
Command Mode
CONFIGURATION
Usage Information
  • IPv4– selection: source-ip destination-ip protocol vlan-id l4-destination-port l4-source-port
  • IPv6 destination address: source-ip destination-ip protocol vlan-id l4-destination-port l4-source-port
  • MAC parameters: source-mac destination-mac ethertype vlan-id
  • TCP/UDP parameters: l4-destination-port l4-source-port

The no version of this command resets the value to the default.

Example (Ingress)
OS10(config)# load-balancing ingress-port enable
Example (IP Selection)
OS10(config)# load-balancing ip-selection destination-ip source-ip
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\