Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

ip pim rp-candidate-timers

Configures the time interval between periodic candidate RP advertisements.

Syntax

ip pim [vrf vrf-name] rp-candidate-timers {ethernet node/slot/port[:subport] | loopback loopback-interface-number | vlan vlan-number | port-channel port-channel-number} {advt-interval interval-value} [hold-time hold-time-value]

Parameters
  • vrf vrf-name—Enter the keyword vrf, then the name of the VRF
  • loopback-interface-number—Enter a value from 0 to 16383
  • vlan-number—Enter a value from 1 to 4093
  • port-channel-number—Enter a value from 1 to 128
  • interval-value—Enter a value from 1 to 26214
  • hold-time-value—Enter a value from 1 to 65535
    NOTE The hold time must be greater than the advertisement interval.
Default
  • Advertisement interval is 60 s.
  • Hold time value is 150 s.
Command Mode
CONFIGURATION
Usage Information

Use this command to adjust the interval between candidate RP advertisements. The advertised RP entries remain in the node until the hold time value expires. Dell EMC recommends configuring the hold time value to be 2.5 times the advertisement interval. The no form of the command resets the candidate RP timers to the default values.

Example
OS10# configure terminal
OS10(config)# ip pim vrf red rp-candidate-timers loopback 10 advt-interval 30 hold-time 80
Supported Releases
10.5.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\