Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

transport

Configures the transport protocol used to stream telemetry data to a remote management device.

Syntax
transport protocol [no-tls]
Parameters
  • protocol — Enter the gRPC (Google remote procedure call) transport protocol used for telemetry sessions.

  • no-tls — (Optional) Disable Transport Security Layer (TLS) certificate exchange with gRPC transport.

Default
OS10 telemetry uses the gRPC protocol for transport with TLS certificates enabled.
Command mode
SUBSCRIPTION-PROFILE
Usage information
gRPC with TLS transport is enabled by default. To use gRPC over TLS transport, you must install a X.509v3 certificate on the switch. To disable TLS certificate exchange, use the transport grpc no-tls command.
NOTE gRPC with TLS transport does not support host certificates. To use a CA certificate, see Request and install host certificates.
The no version of the command removes the configured transport protocol from a subscription profile.
Example
OS10(conf-telemetry)# subscription-profile subscription-1
OS10(conf-telemetry-sp-subscription-1)# transport grpc
Supported releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\