Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

service-policy

Configures the input and output service policies.

Syntax
service-policy {input | output} [type {qos | queuing | network-qos}] policy-map-name
Parameters
  • input — Enter to assign a QoS policy to the interface input.
  • output — Enter to assign a QoS policy to the interface output.
  • qos — Enter to assign a qos type policy-map.
  • queuing — Enter to assign the queuing type policy-map.
  • network-qos — Enter to assign the network-qos type policy-map.
  • policy-map-name — Enter the policy-map name. A maximum of 32 characters.
Default
Not configured
Command Mode
INTERFACE
Usage Information
Attach only one policy-map to the interface input and output for each qos and queuing policy-map type. You can attach four service-policies to the system QoS — one each for qos, queueing, and network-qos type policy-maps. When you configure interface-level policies and system-level policies, the interface-level policy takes precedence over the system-level policy.
Example
OS10(conf-if-eth1/1/7)# service-policy input type qos p1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\