Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

port mode Eth

Configures a Z9264F-ON QSFP28 port group to operate in Ethernet mode, with the specified speed on activated interfaces.

Syntax 
port node/slot/port mode Eth port-mode
Parameters
  • node/slot/port — Enter the interface type details.
  • mode Eth — Configure a port group in Ethernet mode and set the speed to:
    • 100g-1x — Reset a port to 100GE mode.
    • 50g-2x — Split a port into two 50GE interfaces.
    • 40g-1x — Set a port to 40GE mode for use with a QSFP+ 40GE transceiver.
    • 25g-4x — Split a port into four 25GE interfaces.
    • 10g-4x — Split a port into four 10GE interfaces.
Default
100g-1x
Command mode
PORT-GROUP
Usage information
  • To view the currently active ports and subports, use the show port-group command. The no version of the command resets port-group interfaces to the default Ethernet port mode/speed.
  • On the S4148U-ON platform, ensure that you use the same breakout mode as you have configured on the peer interface. For example, if you have explicitly configured the interface on the peer device as 10g-4x, use the same configuration on your switch.
Example 
OS10(config)# port-group 1/1/2
OS10(conf-pg-1/1/2)# profile restricted
OS10(conf-pg-1/1/2)# port 1/1/3 mode Eth 25g-4x
OS10(conf-pg-1/1/2)# exit
OS10(config)# interface ethernet 1/1/3:2
OS10(conf-if-eth1/1/3:2)#
Supported releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\