Alienware 17 R4 Service Manual

Procedure

1. NOTE: Clean the adhesive thoroughly on the palm-rest assembly to avoid having gap between the touchpad and the palm-rest assembly.

   Using the alignment posts on the palm-rest assembly, place the touchpad to the palm-rest assembly.
   
2. Align the screw holes on the touchpad bracket with the screw holes on the palm-rest assembly.
3. Replace the five screws (M2x3) that secure the touchpad bracket to the palm-rest assembly.
4. Slide the touchpad cable and touchpad-buttons cable into their respective connectors on the touch pad and close the latches to secure the cables.
5. Slide the touchpad cable into the connector on the system board and close the latch to secure the cable.