Alienware 17 R4 Service Manual

PDF

Procedure

  1. Using the pull-tab, disconnect the hard-drive cable from the system board.
  2. Remove the hard-drive cable from the routing guides on the computer base.
  3. Remove the four screws (M2.5x5) that secure the hard-drive assembly to the computer base.
  4. Lift the hard-drive assembly along with its cable off the computer base.
    Image: Removing the hard-drive assembly
  5. Remove the four screws (M3x3) that secure the hard-drive bracket to the hard-drive assembly.
  6. Lift the hard-drive bracket off the hard-drive assembly.
    Image: Removing hard-drive bracket
  7. Disconnect the interposer from the hard drive.
    Image: Disconnecting the interposer

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\