Alienware 17 R4 Service Manual

PDF

Procedure

  1. Connect the tron-light cables, the logo-board cable, and the Alienhead cable to the logo board.
  2. Push the latch that secures the Alienhead cable to the logo board.
  3. Turn the logo board over.
  4. Using the alignment post, place the logo board on the display back-cover and antenna assembly.
  5. Align the screw holes on the logo board with the screw holes on the display back-cover and antenna assembly.
  6. Replace the two screws (M2x3) that secure the logo board to the display back-cover and antenna assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\